REV4.0.0 1910012825 AC1900 MU-MIMO Wi-Fi Range Extender / RE550 AC1750 Wi-Fi Range Extender / RE450 User Guide Configure the plug/switch via Kasa app and connect it to the Wi-Fi network of Deco; Launch Deco app, tap the Add icon at the upper right corner, then choose Smart Devices -> Switchs/Plugs/Outlets -> Smart Plug/Smart Light Switch (TP-Link). Tap NEXT, the app will say Searching…. Wait up to 30 seconds until the device is discovered. Here is a configuration example for 802.1Q VLAN. Network Topology: Network Requirement: Hosts in the same department can communicate with each other. Hosts in different departments cannot communicate with each other. Both department A and department B can visit the FTP server. Configuration Scheme: In Windows 11, select Start, type control panel, then select Control Panel > Network and Internet > Network and Sharing Center . Select Set up a new connection or network. Select Set up a new network, then choose Next. The wizard will walk you through creating a network name and a security key. Connect a computer directly to the TP-Link router using Ethernet. Open a browser and type the IP address on the label of the router. This is usually 192.168.1.1 or 192.168.0.1. You should see the Step1. Configure Multi-Nets NAT and Static Route on the Gateway Router. Since there are multiple subnets requiring NAT service, the gateway which works as a NAT device needs to support Multi-Nets NAT. In gateway router’s Web UI, you can configure it in Advanced -> NAT -> Multi-Nets NAT as the figure shows below. 875Wq25.

c wi fi smart link configuration